M1
P1000360

All pictures below show our cured  products being
exposed long term to different types of aggressive chemicals.

Our silicates are even permanently resistant to aggressive chemicals, which can easily be used to etch a hole into even the toughest materials such as stainless steel.

This picture shows a hammer which was subjected to regular drips of high conc.
acid and in comparison our silicate material is being kept in high conc.acid for many months without any change to the material.

 
Unbenannt-1

This picture shows comparison between
epoxy resin and the Maleki silicate product:
Both cured samples are  submerged in highly concentrated Nitric acid.
No epoxy based product can cope with such
aggressive environments for very long! in the world can survive such load for one hour.
Our silicate products are totally long term resistant  to all acids in high concentrations.
Epoxy has as well huge problems with organic acids where again the silicate product is not being affected.

 
5% sodium sulfate02 10% acetic acid02 10% citric acid02 10% lactic acid02
10% phosphoric acid 20% hydrochloric acid acetone 5% ammonium sulfate04
diesel
petrol benzol brake fluid
ethanol High conc. Ammonia02 High conc. boracic acid02 High conc. lactic acid03
High conc.formic acid High conc. phosphoric acid02 High conc. sulfuric acid 02 High conc.citric acid
High conc.acetic acid toluene02 isopropanol High conc.sodium sulfate
High conc.ammonium sulfate